We are going to put you to work today, but just for about 10 minutes. Yep, that’s all it will take for these two essential water heater maintenance jobs; nevertheless, Water Heater Repair Los Angeles understands they will do an excellent job of helping with three things:
Having your water heater last as long as possible (that will save you cash).
Seeing to it the water heater runs safely (we do not want it to explode).
Having it run as energy efficiently as possible (likewise conserving you money).
So with that in mind, are you prepared to invest 10 minutes once or two times a year to assist in saving some cash? Water Heater Repair Los Angeles CA thought so.
Testing the T&P Relief Valve
Typically called the T&P Valve, or the temperature and pressure relief valve, has a vital task. It assists make sure excess pressure does not develop inside the water storage tank, or in much more easy terms, it makes certain the water heater does not explode. As the infographic below reveals, it has a lever or little deal with on it. All you need to do is raise it part way and then let go of it. Hopefully, it snapped back to its closed position rapidly. If it is working appropriately, a little water can be heard entering into the drain pipe below the lever you just lifted and you maybe heard some pressure being released. If none of these things have happened throughout the test, the valve will should be replaced.
Carry out a Mimi Water Heater Tank Flush
By nature, rust and rust will occur inside the water tank thanks to the chemical reactions taking place with all the components inside that are needed to heat the water. We will not get too technical here, but it is easy to assist avoid this from happening by doing a flush or draining of all or a portion of the water in the tank.
For just a tiny flush, place a bucket under the drain valve below the tank. Open the drain valve and fill the pail with water. Drain a minimum of a couple of gallons of water in all. Let the water sit in the pail for a few minutes to settle and analyze if there is much that settles to the bottom of the container. If there is, if the water heater has actually not been drained for a long time (or ever), it would be best to do a complete flush of the tank to get as much of the sediment out as possible. You will want to turn the temperature dial down and may wish to let the water cool off for about an hour initially so it is not too hot while draining it. Likewise, it would be easier to connect a hose to the drain valve and let the water go outside instead of using containers.
If the water looks fairly clean and clear from the mini test you should be all set. When the water heater has a large amount of sediment inside of it, it can make loud popping sounds and it lowers its efficiency too.
Though water heaters are fairly upkeep free and not difficult to run, whenever you feel the smallest awkward or are unsure of what to do, it is always best to have a plumbing professional help with the scenario.